If your kitty sends litter sailing out of your Litter-Robot onto the floor, try the fence accessory. It fastens onto the entrance of the Litter-Robot 3 and acts as a barrier to contain kicked-up litter. It rises just a few inches (so your cat can still enter the globe easily), but that difference goes a long way toward keeping the litter box area clean.
The fence also helps ensure that your cat is all the way inside the globe before going. If you have one of those cats that doesn’t turn around once they’re in the globe, the fence accessory is a great solution. It promotes your cat’s full entry into the globe, helping to prevent those half-in/half-out messes.
The fence also helps protect the black rubber liner. It’s made of a tough but flexible plastic that can withstand your kitty’s scratching. If it gets dirty, it’s quick to pop off, wash, and reinstall.
To install the Litter-Robot 3 Fence:
- Hold the fence upright inside the globe.
- Tilt the bottom of the fence toward you to align the back of the fence with the built-in kickguard on the globe.
- Keep the wing tabs of the fence inside the globe while rotating it downward. Gently pull forward and push down on the front of the fence to snap it over the lip of the globe.
- Make sure the fence is level and the three tabs along the outer rim of the fence are secured over the lip.
Check out the Fence installation video here or download the Installation Guide attached below.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article