LR 3 | Carbon Filter and Base Seal Installation

Created by Ken MacCormick, Modified on Sat, 28 May, 2022 at 4:56 AM by Ken MacCormick

The carbon filter and gray, brush-type base seals are designed to contain odor within the drawer. The replacement frequency of both accessories is based on personal preference. Replacement carbon filters and base seals can be ordered on our website under accessories at catevolution.com.au.

See the full set of instructions below to learn how to replace your carbon filter and base seals.


Remember, you may always give Customer Service a call at 1300 350 635 Monday through Friday. You can also e-mail us at [email protected].


Carbon Filter Replacement

WATCH VIDEO TUTORIAL
 To remove:

1. Grab the bottom corner of the filter and pull down, away from the drawer step.
  

To install:

1.  Slide filter into rib located near the inside front wall of the waste drawer. 

2.  Fit the top edge of the carbon filter under the four hooks as shown below.

3.  Be sure that the carbon filter is properly covering the waste drawer vent completely. You may need to pull the top edge of the filter up once fitted under the hooks.
  

Base Seal Replacement

To remove:

1. Pull up on old strip and peel off.

2. Use a cotton ball and rubbing alcohol to remove any excess adhesive from the old seal.

3. Make sure surface is dry before installing new seals.
  

To install:

1. Peel back the protective strip 3-4 inches from the adhesive backing of the seal. 

2. Place the adhesive side of the strip above the rib.

3. Press down firmly on the base seal and peel back the remaining protective backing as you go along.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article